Name

Name

arshiya

Personal details

Web

http://clearlyfilteredwaterpitcher.com/

Short Bio

Beginning the Installation

Once you have the right tools for the job, Clearly Filtered Water Pitcher Review installation is easy. Start by locating where you want to mount the dispenser. If you plan to mount the dispenser through the countertop, place some masking tape over the area you will be drilling through to help prevent splintering. If you plan to mount the dispenser through a metal sink shoulder, drill slowly if using a hole saw to prevent overheating the bit. After drilling the dispenser mounting hole, place the dispenser mounting shaft through the hole and secure with the supplied hardware.

Finding a Water Source to Tap In To

The next step is to locate a suitable place for the tee fitting in the cold water line going to the sink faucet. The tee fitting taps in to the line and provides the water supply connection for the dispenser. You can tap in to any cold water line but under the sink is the most convenient. Here is where you use your handy dandy PEX tubing cutter. Before cutting, be sure your water pump it switched off and all pressure in the line is relieved. Otherwise you're in for a real mess. Now carefully cut a 1" section out of the cold water line, which will require two cuts. If you have enough room to move the lines away from each other 1", then you may not have to do the second cut.

Installing the Tee Fitting

Water filter kits usually come with all the fittings necessary for a typical installation. This mod uses a plastic tee fitting which slips in between the cut tubing and a brass shutoff valve that serves both to provide the water supply to the dispenser and to turn off the supply if you need to change the filter or winterize. Thread the brass fitting in to the tee fitting using plumbers tape around the threads to prevent leakage.

Fitting the Brass Water Supply Shutoff Valve

Next, the water supply tubing needs to be attached to the brass shutoff valve. Don't worry about the length of the tubing at this point. The idea here is to secure the tubing to the fitting first since doing this requires a couple of end wrenches to secure. You might not have much room to use the wrenches in a tight compartment. The brass fitting is a compression type fitting so you need to slide the compression nut on first, then the small compression ferrel. Insert the tubing in to the fitting and tighten the compression nut fairly tight but not too tight.

Now secure the plastic tee fitting to the cold water line by sliding the round plastic threaded nuts on to each side of the cut tubing, then insert the tee fitting. Secure the nuts to the fitting taking care to not over tighten. You can use pliers to do this but make sure you hold the fitting body securely so you don't damage the water line.

Mounting the Water Filter Cartridge

The next step is to mount the http://clearlyfilteredwaterpitcher.com/ water filter. Find a suitable location near the the tee fitting you just installed. The mod shown in the pictures uses a simple plastic bracket that the filter snaps in to. Secure the bracket and snap the filter in to place. Now you can measure how much tubing you need to go from the dispenser to the filter, and from the filter to the shutoff valve. Measure the distance for each and then add 6". This extra tubing will help with any bends required when routing the tubing. Cut the tubing with the tubing cutter to the appropriate length.

Attaching the tubing is incredibly simple with the type of filter and dispenser used in this mod. All you have to do is insert the tubing in to the ends of the filter and in to the bottom of the dispenser. No compression fittings or special tools are required. The tubing may appear to be loose in the filter and dispenser but try pulling the tubing out. You can't. The fittings hold the tubing in place and water pressure actually prevents the connections from leaking. Just be sure to connect the lines correctly, observing the filter input and output arrows.

 

History

Member for

9 years 7 months