I downloaded the ProcessMaker image to run on VMware. I found it was running ProcessMaker 2.0 and the latest version, 2.5.1, from source forge and started running though this guide from their Wiki. I got stuck at this command that I need to run.

So, I'm running the standard appliance version of Canvas, and there are many bugs. So, I see that there's a version of Canvas on the shiny new TKL git repo, and it was updated 4 days ago, so maybe that's what I need. 

But I can't find anything to get me started. How do I proceed? I'm assuming I create a new server, and clone from the git repo, but I'm looking for a good end-to-end guide on how to do this. 

Hi all,

I have been using the TKL file server version 12.0 in our environement installed on a VM environment and have been facing several issues of the system getting corrupt of the Busybox & initramfs which required me to rebuild the server multiple times.

Can anybody advise if this issue has been taken care in TKL File server version 12.1 for the VM environment? If yes, please share some details on this.

Thanks

Hi,

I have installed lamp on a vmware host.

Everytime i reboot or after a certain amount of time 10-15 minutes, I get disconnected from my ssh. 

Only thing i can do then is reënter the iptables config.

How can i fix this?

(when i boot up i have to enter the commands to).

Thnx in advance

Hey guys,

I don't know how to name this topic cause I don't really know what is the problem. I chose TurnKey Linux for my WordPress blog (62.113.218.119) but I have problems with the setup. Suddenly the server stops working properly and the blog is down. What to do?

PS: It's WordPress multisite (network).

I installed a new instance from Amazon with Magento.

So, the config of ftp on magento connect is empty, how I can config this?

Thanks.

Where can I find directions for just confconsole?  I'd like to use it to allow client to configure the IP address of an applaince I am developing, but I don't want all the extras included in the core build.  I just need confconsole.

Thanks,

Eric

Hello,

Im al little bit confused but can I install turnkey linux on my own hard disk of 80G.

And if so, where can I find how to do this ?

Roelof

hi,

I'm just starting out with Git...  I have a little issue with branching:

I'm in branch master; I create a new branch; checkout new branch (called 'test'); I make changes and save them; I switch back to branch master; but changes I made in branch 'test' are still there... they do not get reverted....

i.e., following what's here,
http://git-scm.com/book/en/Git-Branching-What-a-Branch-Is

if you look right underneath figure 3.8, where it says

What is the php version, on Magento - Flexible eCommerce Platform powered by TurnKey Linux?